*Parts subject to wear and tear such as seals and rubbers are not covered by warranty.

Parts covered by warranty:

*If flushing cleaners or chemical additives are used in the cistern, all warranties will be void.

We will rectify free of charge for parts within these periods, any fault due to a defect in materials appearing within the applicable warranty period subject to the conditions set out below.

Claims for BelBagno products which were installed and used according to installation instructions and by alicensed plumber (electrician for LED mirrors and cabinets) only are accepted.

Important! Please read prior to installation

Prior to installation, it is important to unpackage &inspect your products to ensure no damage has occurred in transit and that the product IS CORRECT. If damage has occurred, or a visible defect exists, do not proceed with the installation.

Contact the distributor that you purchased this product from with any enquiries regarding the condition of the product or any defects PRIOR to installation.

NO claims for damages/defects will be recognized after installation.

Regardless of any warranty service within the warranty period, the warranty shall expire at the end of the timeframe set out above from the original date of purchase.

Australian Consumer Law Guarantee

“Our goods come with guarantees that cannot be excluded in the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.”


To the fullest extent permitted by law, BelBagno Australia excludes all liability for damage or injury to any person, damage to any property, and any indirect consequential or other loss or damage. BelBagno Australia will not be liable to bear the expense of claiming the warranty (i.e. time off work, postage, etc).


For all warranty queries customers are to contact the branch where the product was purchased. These details can be found on your purchase invoice.

1. In all cases customers must provide an original purchase receipt (a copy will not be accepted) as a PROOF OF PURCHASE, and installer’s details including ‘license’ number and confirmation of the water pressure if the warranty claim is in relation to the cistern internals. Without this information we will be unable to process the warranty claim.

2. Provide details of the model, finish and nature of the problem to enable the identification and rectification of any fault.

3. Provide detailed photos of the defect.

4. We will then assess your claim to determine the nature of the issue, and whether you are entitled to a replacement under the warranty.

Submit the warranty form on our website.

Please do not bring the item back to us as we will not replace it without the warranty claim.

You will be required to leave the product in place until we contact you with further instructions or details as warranty is void if the item is uninstalled without the manufacturer’s permission. We will get back to you within3 business days to solve your matter.

Claims for damage made a week after receiving the items will not be accepted.Claims made for charges other than the item will not be accepted, including plumbing charges and postage fee.


Improper functioning of product due to incorrect installation.
Damage due to incorrect installation.
Damage due to accident.
Damage due to secondary transit or handlingImproper care and cleaning.
Alterations to original productInappropriate use and/or abuse of item/vandalism.
Failure to use or maintain items in accordance with the manufacturer's recommendations.
Installations in public areas or high use areas.
Damage from third party equipment.
If the product is not installed by a licensed plumber all warranties are void.

- Toilet pans shall not be installed on a sand and cement mix in which case the warranty will be void
- Furniture surfaces are for use in normal bathroom conditions including adequate ventilation, removal of excessivesurface water and proper sealing of any cracks in order to prevent water penetration.
- Waste is not to be over tightened to avoid stress on basin or top (recommendation for waste to be HAND tight only,silicone sealed).
- Acrylic baths and shower tray products need to be inspected by the purchaser for scratches and/or cracks prior toinstallation, no warranty is offered post-installation.
- Doors and drawers have to be adjusted if required as there may have been some movement during transportationand installation.
- BelBagno Design vanity cabinets, shaving cabinets and side cabinets are manufactured from Moisture Resistantmaterials but are not waterproof. Care must be taken to dry spillages or leakage of water that may gain access tocabinetry. Accurate sealing of the cabinet and kickboard (where applicable) is vital for proper maintenance of theproduct and ensuring longevity.
- Under no circumstances should vanities and/or tops be tiled into the wall. BelBagno vanities and basin/tops mustbe fitted to finished/completed wall coverings. The BelBagno Warranty does not cover any vanity and/or top and/orbasin that has been tiled ‘into’ a wall i.e., fitting or fixing a vanity to a wall and tiling around it, and/or tiling downand/or around the vanity and top/basin.
- BelBagno Design mirrors/ mirrored cabinets.
– It is the responsibility of the purchaser to ensure the product is installedand maintained appropriately. Care should be taken to avoid contacting mirror edges with any liquid. 


The maximum working pressure is 500kpa (as Australian Standards). Water pressure over this or poor water quality willvoid the warranty. Please Note: 95% of warranty claims associated with cistern internals are due to high water pressureand/or poor water quality, or incorrect adjustment of inlet and/or outlet value or not checking for water tightness ofinlet/outlet value at installation. All Geberit and BelBagno

Seat covers are not designed for standing on. The seat may become loose with time and through use – this is normaland needs simple ongoing maintenance and will not be considered a warranty issue.
This warranty is for normal domestic and commercial use only and excludes any defect or injury caused by or resultingfrom misuse, abuse or neglect, accidental damage, improper installation or other alterations or modifications whichaffect the reliability or performance of the unit not attributable to faulty manufacture. This warranty does not coverdefects or injury caused by or resulting from poor installation or installation outside of National or Regional governmentstandards. All our seats come with 12 months warranty. 

Submit Warranty

There are no products to list in this category.